GURU FLY REEL

The Guru S Series builds on the hugely popular Guru reel by incorporating placid, organic design features that not only reduce weight, but also add strength in the most important parts of the reel's structure. Guru is our very popular and lowest priced fully machined reel, now in its third generation with updated spool geometry for better retrieve speeds, open ports to reduce weight and improve line drying, and an integrated counterweight for structural stability. Guru sets the standard for CNC machining quality and reliability at a great price. Made in the USA and assembled in Boise, Idaho. allowing dimensions of structure and function to inspire beauty.

- Format: Large Pergola

- Materials: Machined 6061 Aluminum, Stainless Steel

- Finish: Type II hard Alox

- Drag: Sealed conical drag system

- Made in the USA, built in Idaho

RECOMMENDED CARE:

1) Do not under any circumstances remove the drag knob or the two-hole nut in the center of the drag knob.

2) Always make sure that the packing cap is tight, especially before using the reel for the first time or after reversing the recovery direction. Be sure to periodically check that the cap is securely inserted; It must always be tightened firmly by hand, do not use a tool. The packing plug should sit fully on the drive cylinder if installed correctly.

3) The drive system is designed to operate without lubrication. Do not use any type of oil or lubricant in or around the drag system. You can apply a small amount of WD-40 to the recovery handle to remove any dirt buildup between the handle and the handle shaft.

Fresh Water Use: Occasionally rinse the reel thoroughly under fresh running water and clean the spool and frame to remove any debris or dirt buildup. Be sure to clean the spool pin and keep it free of debris.

Salt water use:

1) Be sure to rinse your reel under fresh running water after each use in a saline environment. Occasionally, flush the clutch by doing the following:

2) Remove the coil, unscrew the packing cap and remove the red and silver clutch assembly.

3) Thoroughly rinse all components, including the inside of the drive cylinder, with fresh running water.

4) Allow all components to dry completely before reassembling them.

TECHNOLOGY:

- Item: Guru -3+, Diameter: 81mm, Width: 33mm, Weight: 106gr, Pin: WF 2-4, Tail Capacity: WF4 60 Yds 20#

- Item: Guru -5+, Diameter: 90 mm, Width: 34 mm, Weight: 125 gr, Pin: WF 4-6, Tail Capacity: WF6 100 Yds 20#

- Item: Guru -7+, Diameter: 101 mm, Width: 37 mm, Weight: 143 gr, Pin: WF 6-8, Tail Capacity: WF8 180 Yds 20#

- Item: Guru -9+, Diameter: 104 mm, Width: 38 mm, Weight: 165 gr, Pin: WF 8-10, Tail Capacity: WF10 200 Yds 20#