FLY REEL GURU HD ARTICO

Totally lit. Rugged and stylish, Guru has long set a standard for enlightened excellence as a rugged, fully machined in the USA, ultra-reliable reel at a great price. By increasing the diameter of the shaft and making the spool narrower, while decreasing its total weight and parts, Guru S takes it to another level. An improved coil processing technique, concentrating the material only where it is needed, makes this version significantly lighter and more performing than its predecessor. We opened the porting to reduce weight and improve line drying, and we integrated the counterweight. We also introduced a curved cross section for structural stability. Bringing your game to fishing nirvana, this will be your Guru for life.

- Format: Large Pergola

- Materials: Machined 6061 Aluminum, Stainless Steel

- Finish: anodized type II

- Drag: Sealed conical drag system

RECOMMENDED CARE:

1) Do not under any circumstances remove the drag knob or the two-hole nut in the center of the drag knob.

2) Always make sure that the packing cap is tight, especially before using the reel for the first time or after reversing the recovery direction. Be sure to periodically check that the cap is securely inserted; It must always be tightened firmly by hand, do not use a tool. The packing plug should sit fully on the drive cylinder if installed correctly.

3) The drive system is designed to operate without lubrication. Do not use any type of oil or lubricant in or around the drag system. You can apply a small amount of WD-40 to the recovery handle to remove any dirt buildup between the handle and the handle shaft.

Fresh Water Use: Occasionally rinse the reel thoroughly under fresh running water and clean the spool and frame to remove any debris or dirt buildup. Be sure to clean the spool pin and keep it free of debris.

Saltwater Use: Be sure to rinse your reel under fresh running water after each use in a salty environment. Occasionally, flush the clutch by doing the following:

1) Remove the coil, unscrew the packing cap and remove the red and silver clutch assembly.

2) Thoroughly rinse all components, including the inside of the drive cylinder, with fresh running water.

3) Allow all components to dry completely before reassembling them.

TECHNOLOGY:

- Reel: GS-5+HDREEL-BLAZE, Model: -5+DV, Diameter: 9 cm, Width: 2.5 cm, Weight: 130 gr, Rod: 4.5-6, Fly Line Weight: WF6

- Reel: GS-7+HDREEL-BLAZE, Model: -7+DV, Diameter: 10 cm, Width: 2.9 cm, Weight: 149 gr, Rod: 6.7-8, Fly Line Weight: WF8, Casting Capacity support: 180 Yds 20#

- Reel: GS-9+HDREEL-BLAZE, Model: -9+DV, Diameter: 10.4 cm, Width: 3.1 cm, Weight: 173 gr, Rod: 8.9-10, Fly Line Weight: WF10, Support Capacity: 220 Yds 30#