LIQUID MAX REEL

Nobody likes a bully. Whoever says this hasn't experienced the new Liquid Max, a bully and a reel beast. The Liquid Max features our Cobalt Drag System: a completely USA-made stop-any drag system with patented Teflon alloy drag cone, PEEK carbon thrust washers, custom self-lubricating seals, and a certified IPX8 waterproof rating. We've housed this drag in a die-cast, machined frame and spool, with features that include an ultra-large spindle, integrated reel seat and pocket spar frame, and spool design that maximizes drag-to-weight ratio. Top it all off with a large, easy-to-grip drag knob, you have a reel that will change your mind about bullies.

- Cobalt Drag System: Made in the USA, IPX8 waterproof certified, proprietary Teflon alloy drag cone, PEEK carbon thrust washers, custom self-lubricating seals

- Ultra large shaft ratios

- Integrated reel seat

- Large, easy-grip handle and drag knob

- Pocket spar and coil design increases weight resistance

- Die-cast and machined frame/coil

TECHNOLOGY:

- ITEM: Liquid max 6, DIAMETER: 108 mm, WIDTH: 25 mm, WEIGHT: 198gr, ROD: WF 6-7, LINE CAPACITY: WF6 150 yds 20#

- ITEM: Liquid max 8, DIAMETER: 117 mm, WIDTH: 25 mm, WEIGHT: 227gr, ROD: WF 8-9, LINE CAPACITY: WF8 250 yds 20#

- ITEM: Liquid max 10, DIAMETER: 127 mm, WIDTH: 28 mm, WEIGHT: 255gr, ROD: WF 10-11, LINE CAPACITY: WF10 250 yds 30#

RECOMMENDED CARE:

1) Do not under any circumstances remove the drag knob or the two-hole nut in the center of the drag knob.

2) Always make sure that the packing cap is tight, especially before using the reel for the first time or after reversing the recovery direction. Be sure to periodically check that the cap is securely inserted; It must always be tightened firmly by hand, do not use a tool. The packing plug should sit fully on the drive cylinder if installed correctly.

3) The drive system is designed to operate without lubrication. Do not use any type of oil or lubricant in or around the drag system. You can apply a small amount of WD-40 to the recovery handle to remove any dirt buildup between the handle and the handle shaft.

4) Fresh Water Use: Occasionally rinse the reel thoroughly under fresh running water and clean the spool and frame to remove any debris or dirt buildup. Be sure to clean the spool pin and keep it free of debris.

Salt water use:

Be sure to rinse your reel under fresh running water after each use in a saline environment. Occasionally, flush the clutch by doing the following:

1) Remove the coil, unscrew the packing cap and remove the red and silver clutch assembly.

2) Thoroughly rinse all components, including the inside of the drive cylinder, with fresh running water.

3) Allow all components to dry completely before reassembling them.