REMIX S FLY REEL

The ultimate hybrid. A fusion of the free-form structures of a cast coil and the mechanical integrity of a CNC-machined case, the Remix S is the ultimate hybrid. Made from bar stock aluminum, the frame offers maximum structural rigidity and durability, all wrapped up in a longer-lasting, shinier anodized finish. The spool (compatible with the Liquid S) is die-cast with pocket spar design and increased strength-to-weight ratio. Remix S improves on the legacy of the first generation Remix with larger diameters, larger pins, greater resistance and a larger, easier-to-grip drag knob. Remix S brings an unmatched level of quality to its category. The result is high performance. Reliability. Quality assurance. Plus, undeniable knockout looks.

- Greater diameter/arbor than the previous generation

- Hybrid frame with machined bar with cast spool

- Redesigned pin shape for cleaner winding

- Redesign the frame structure for greater durability and strength

- Pocket Spar coil design: greater resistance to weight

- Large, easy-grip drag knob

- Updated style

TECHNOLOGY:

- ITEM: Remix S -3+, DIAMETER: 81 mm, WIDTH: 25 mm, WEIGHT: 122gr, ROD: WF 2-4, LINE CAPACITY: WF4 60 yds 20#

- ITEM: Remix S -5+, DIAMETER: 90 mm, WIDTH: 25 mm, WEIGHT: 130gr, ROD: WF 4-6, LINE CAPACITY: WF6 100 yds 20#

- ITEM: Remix S -7+, DIAMETER: 101 mm, WIDTH: 29 mm, WEIGHT: 156gr, ROD: WF 6-8, LINE CAPACITY: WF8 180 yds 20#

- ITEM: Remix S -9+, DIAMETER: 104 mm, WIDTH: 32 mm, WEIGHT: 204gr, ROD: WF 8-10, LINE CAPACITY: WF10 200 yds 30#

RECOMMENDED CARE:

1) Do not under any circumstances remove the drag knob or the two-hole nut in the center of the drag knob.

2) Always make sure that the packing cap is tight, especially before using the reel for the first time or after reversing the recovery direction. Be sure to periodically check that the cap is securely inserted; It must always be tightened firmly by hand, do not use a tool. The packing plug should sit fully on the drive cylinder if installed correctly.

3) The drive system is designed to operate without lubrication. Do not use any type of oil or lubricant in or around the drag system. You can apply a small amount of WD-40 to the recovery handle to remove any dirt buildup between the handle and the handle shaft.

4) Fresh Water Use: Occasionally rinse the reel thoroughly under fresh running water and clean the spool and frame to remove any debris or dirt buildup. Be sure to clean the spool pin and keep it free of debris.

Salt water use:

Be sure to rinse your reel under fresh running water after each use in a saline environment. Occasionally, flush the clutch by doing the following:

1) Remove the coil, unscrew the packing cap and remove the red and silver clutch assembly.

2) Thoroughly rinse all components, including the inside of the drive cylinder, with fresh running water.

3) Allow all components to dry completely before reassembling them.